Mercedes-Benz OM629 engine


The Mercedes-Benz OM629 is a diesel-fuelled, 4-stroke, compression-ignition internal combustion 75° 32-valve V8 engine used in the 2000s.

Design

The block features an aluminium crankcase and cylinder heads. It uses aluminium sand casting in bedplate construction with wet cylinder liners made of cast iron.
The main bearings are reinforced, cast in GGG ductile cast iron. Rather than the usual 90° "vee" angle between the cylinder banks, a 75° angle was chosen due to the space available to install the engine. The consequence of this specific angle is free inertial forces of the first order. To compensate for this, the OM628 and OM629 use a balancer shaft located in the vee of the engine. To ensure even firing intervals the crankshaft uses split crank pins. The engine uses 97.0 mm cylinder spacing.
The engine uses dual overhead camshafts on each bank with four valves per cylinder, operated by hydraulic tappets. Each cylinder bank uses a variable geometry turbocharger. The compressed air from these is cooled by an air to water heat exchanger with an additional cold water circuit.
Compared to the OM628, the OM629 engine has an improved common-rail system, and higher boost from the turbochargers. It displaces and produces between at 3600 rpm, and of torque between 2000–2600 rpm.

Models

OM629 (225 kW version)

OM629 (231 kW version)

OM629 (235 kW version)