Initialization vector
In cryptography, an initialization vector or starting variable is an input to a cryptographic primitive being used to provide the initial state. The IV is typically required to be random or pseudorandom, but sometimes an IV only needs to be unpredictable or unique. Randomization is crucial for some encryption schemes to achieve semantic security, a property whereby repeated usage of the scheme under the same key does not allow an attacker to infer relationships between segments of the encrypted message. For block ciphers, the use of an IV is described by the modes of operation.
Some cryptographic primitives require the IV only to be non-repeating, and the required randomness is derived internally. In this case, the IV is commonly called a nonce, and the primitives are considered stateful rather than randomized. This is because an IV need not be explicitly forwarded to a recipient but may be derived from a common state updated at both sender and receiver side. An example of stateful encryption schemes is the counter mode of operation, which has a sequence number for a nonce.
The IV size depends on the cryptographic primitive used; for block ciphers it is generally the cipher's block-size. In encryption schemes, the unpredictable part of the IV has at best the same size as the key to compensate for time/memory/data tradeoff attacks. When the IV is chosen at random, the probability of collisions due to the birthday problem must be taken into account. Traditional stream ciphers such as RC4 do not support an explicit IV as input, and a custom solution for incorporating an IV into the cipher's key or internal state is needed. Some designs realized in practice are known to be insecure; the WEP protocol is a notable example, and is prone to related-IV attacks.
Motivation
A block cipher is one of the most basic primitives in cryptography, and frequently used for data encryption. However, by itself, it can only be used to encode a data block of a predefined size, called the block size. For example, a single invocation of the AES algorithm transforms a 128-bit plaintext block into a ciphertext block of 128 bits in size. The key, which is given as one input to the cipher, defines the mapping between plaintext and ciphertext. If data of arbitrary length is to be encrypted, a simple strategy is to split the data into blocks each matching the cipher's block size, and encrypt each block separately using the same key. This method is not secure as equal plaintext blocks get transformed into equal ciphertexts, and a third party observing the encrypted data may easily determine its content even when not knowing the encryption key.To hide patterns in encrypted data while avoiding the re-issuing of a new key after each block cipher invocation, a method is needed to randomize the input data. In 1980, the NIST published a national standard document designated Federal Information Processing Standard PUB 81, which specified four so-called block cipher modes of operation, each describing a different solution for encrypting a set of input blocks. The first mode implements the simple strategy described above, and was specified as the electronic codebook mode. In contrast, each of the other modes describe a process where ciphertext from one block encryption step gets intermixed with the data from the next encryption step. To initiate this process, an additional input value is required to be mixed with the first block, and which is referred to as an initialization vector. For example, the cipher-block chaining mode requires an unpredictable value, of size equal to the cipher's block size, as additional input. This unpredictable value is added to the first plaintext block before subsequent encryption. In turn, the ciphertext produced in the first encryption step is added to the second plaintext block, and so on. The ultimate goal for encryption schemes is to provide semantic security: by this property, it is practically impossible for an attacker to draw any knowledge from observed ciphertext. It can be shown that each of the three additional modes specified by the NIST are semantically secure under so-called chosen-plaintext attacks.
Properties
Properties of an IV depend on the cryptographic scheme used. A basic requirement is uniqueness, which means that no IV may be reused under the same key. For block ciphers, repeated IV values devolve the encryption scheme into electronic codebook mode: equal IV and equal plaintext result in equal ciphertext. In stream cipher encryption uniqueness is crucially important as plaintext may be trivially recovered otherwise.Many schemes require the IV to be unpredictable by an adversary. This is effected by selecting the IV at random or pseudo-randomly. In such schemes, the chance of a duplicate IV is negligible, but the effect of the birthday problem must be considered. As for the uniqueness requirement, a predictable IV may allow recovery of plaintext.
Depending on whether the IV for a cryptographic scheme must be random or only unique the scheme is either called randomized or stateful. While randomized schemes always require the IV chosen by a sender to be forwarded to receivers, stateful schemes allow sender and receiver to share a common IV state, which is updated in a predefined way at both sides.