Ducati Sebring
The Ducati Sebring is a single cylinder bevel drive SOHC motorcycle produced by the Italian manufacturer Ducati from 1965 to 1968. At the time of its introduction it was the largest capacity Ducati machine. Production of the original model ended in 1967 when the 'wide case' Mark 3 was introduced, although just over 200 Sebrings were made in 1968 with the 'wide case' engine. Total production was around 3,500 machines.
History
Ducati's primary market at the time was the US. Their American importers, Berliner Motor Corporation, had been importing the Fabio Taglioni designed range of singles, the largest of which had a displacement of 250 cc. For 1965 Berliner had requested a larger version. Taglioni stretched the 250 to 340 cc but had concerns about the reliability of the bottom end, so the Sebring was produced in a mild state of tune with soft camshafts, small valves and a restrictive 24 mm carburettor.It was a practice of Ducati at the time to name models after race circuits where they had won. Works rider Franco Farne had competed in a 251-700 cc race at Sebring on a 350RC racer, finishing 11th overall and winning the 350 class. The Sebring was named after this race.
When launched in 1965 the bike shared similar styling to the 250 Monza, but later that year the styling was revised using the larger, angular tank and other cycle parts used on the 250 Diana.
The American motorcycle market slumped and in 1967 Berliner were in financial trouble and refused a consignment of 3,500 machines from the factory. These machines were sold to Liverpool businessman Bill Hannah, who sold the bikes to the public between 1968 and 1972. A lot of these were Sebrings which were sold at a discounted price. By 1972, 400 machines remained unsold and these were sold to journalist and dealer Mick Walker who dismantled them for spares. Hannah offered no support or spares network for the bikes he sold which damaged Ducati's reputation in the UK.
In 1968 just over 200 Sebrings were produced using the 'wide case' engine. These had a higher compression ratio of 9.5:1.
Technical details
Engine and transmission
The 350 engine was an enlarged version of the company's 250 Monza, using the same soft cam and small valve head. The single cylinder bevel drive OHC engine was of unit construction and had alloy head and alloy barrels with cast iron liners. The 250's bore was increased to and the stroke increased to giving a displacement of. A Borgo 3 ring piston was fitted which gave a compression ratio of 8.5:1. Claimed power output was @ 6,250 rpm, giving the machine a top speed of. Starting was by a kickstarter on the left side of the bike and a decompression lever fitted to aid kicking the engine over.Fuel was delivered by a remote-float 24 mm Dell'Orto carburettor. The engine used wet sump lubrication.
Primary drive was by helical gears to a multi-plate wet clutch. The Sebring had a higher primary drive ratio than the 250s. The 5 speed gearbox that had been introduced on other models in '65 was used. Chain drive took power to the rear wheel.