Drascombe
The word Drascombe is a trademark that was first registered by John Watkinson who applied it to a series of sailing boats which he designed and built in the period 1965–79 and sold in the United Kingdom. They comprised the Coaster, Cruiser Longboat, Dabber, Drifter, Driver, Gig, Launch, Longboat, Lugger, Peterboat, Scaffie, Scaith and Skiff, together with a few other one-offs. They have wide and deep cockpits, adaptable boomless rigs and high bulwarks.
The word drascombe is also used as a generic term for any boat built to a design by John Watkinson. These include both 'the Drascombe range' build by Churchouse Boats and the 'Original Devon' range produced by Honnor Marine,
The Caboteur and Drifter 22 have been designed and built recently following the design principles developed by John Watkinson.
John Watkinson died in 1997 and the trademark is now owned by his surviving family. The only licensed builder of the Drascombe range is Drascombe Boats.
Past licensees include Churcbouse Boats, McNulty; John Elliott and Douglas Elliott Boatbuilders ; and Kelly and Hall, which built the original production Luggers in wood.
Design principles
There are basically two types of drascombe. There are undecked open day sailers and one or two-berth weekenders. They were originally designed and built in marine plywood using glued lapstrake construction. As they became more popular, they were then manufactured in GRP.The hull, typically, consists of four strakes each side, the garboard strakes being wide giving a flat run to the transom whilst having a fairly sharp entry at the stem. There is a recessed rear deck level with side benches and a recessed foredeck. Some models have a small one or two-berth cabin.
The transom slopes back at an angle of about 45 degrees with the top edge sloping forward giving drascombes a distinctive appearance at the stern. Just forward of the transom is a well to take an outboard motor with a slot in the transom that allows the outboard motor to be tilted out of the water when under sail. It also keeps the outboard motor hidden from view.
The usual rig consists of a Gunter rigged mainsail set on the main mast, a mizzen sail set on the mizzen mast sheeted to a bumpkin and a foresail. The tan-coloured sails are all boomless to avoid possible head injury from a gybing boom. The original Drascombe Lugger had a lug sail to start with; this was changed to a gunter mainsail but the name was kept.
The rudder fits in a case which is set in the aft deck in front of the mizzen mast. It can be lifted up into the case when in very shallow water.
A steel centreboard is in a centreboard case with a purchase to lift it.
Some have a conventional vertical transom with the rudder hung on the transom.
Some were double enders with a canoe stern. Of these, the Skiff has no outboard motor well, just a mini triangular transom to take a small outboard motor when the rudder has been removed.
Flotilla
Caboteur
The Caboteur is based on the drascombe Longboat but modified to the requirements of French drascombe aficionado Jean-Louis Grenier to create his "ultimate drascombe camping cruiser"Originally in wood epoxy the hull is now available in GRP. It is 8" wider in the beam than the Longboat with 3" more freeboard. The rig is also larger and a cruising chute can be set to a bowsprit.
Jean-Louis' boat has a large sleeping platform and a vast amount of dedicated storage. The great number of lockers, together with the added beam and freeboard make the sailing weight nearly twice that of a Longboat.
Coaster
A trailer-sailer with a two-berth cabin including cooking and toilet facilities. Replaced the Cruiser Longboat, having a much improved specification, especially with regard to the cockpit and cabin layouts.Cruiser Longboat
A Longboat with a cabin of two berths or one berth and a galley bench. Unlike the open Longboat and other drascombes a boom was fitted to the mainsail. Designed to appeal more to private buyers than the open version, the Cruiser Longboat was introduced and sold side by side with the standard open boat. Introduced in 1970 and replaced in 1979 by the Coaster. Over 400 were built. The wooden versions were all custom built and differ considerably from the GRP versions.Dabber
Although smaller than the Lugger, the Dabber carries a full yawl rig on main and mizzen masts. However, the Dabber can easily be distinguished by its bowsprit and transom-hung rudder.Drifter
A cruising boat with a cabin and choice of outboard well or 6-8 hp Sabb inboard Diesel engine. Draft 2'+. Long keel with fixed bilge plates. Original spec included sails with roller-reef jib, pramhood canopy, two-burner paraffin cooker, flushing chemical toilet, fitted bilge pump, anchor warp and chain; anti-fouling below waterline. An optional tent was also available, extending sleeping accommodation from two to four adults.Drifter 22
At the 2007 London Boat Show Churchouse Boats launched the Drifter 22.Paul Fisher of was employed to revise the design of the original Drifter.
The prototype was built in wood/epoxy but moulds have been made and production boats are manufactured in GRP.
In 2021 Churchouse Boats re-launched the Drifter 22 with a Mark II model, under the Drascombe Boats brand.
Driver
An 18' version of the Launch hull with bilge fins for sailing. A Watermota Shrimp inboard petrol engine with fully feathering propeller was fitted. A petrol/paraffin version of the Watermota or even a diesel were available to special order. For sailing it had a standing lug rig similar to the Dabber but with a slightly larger jib and mainsail.Gig
Never intended for the private buyer, the Gig is a pure sail training craft designed for use by Navies. Previously, the Royal Navy used the Montagu Whaler for this purpose, but these boats were getting well past their best, and new ones have not been built since the 1950s. The Longboat was considered too small, so the Gig was designed for this specific market. The French navy now uses four Gigs for this purpose.Today a number of privately owned Gigs are about - two were fitted with cabins. One was fitted with a tent to allow for extensive cruising.
In private hands the Gig is not for the novice. She has a fairly big sail area and handles and feels like a big boat. At the same time, once in tune with her, she gives her crew great confidence by her easily reefed lug sail and her sea keeping capabilities.
Launch
Based on the Dabber hull and introduced in 1973, the Launch was designed for river and lake fishing. Fitted with a Watermota Shrimp inboard engine and a Dabber mizzen as a steadying sail. Not a very successful model, only 12 being built.Longboat
Essentially a stretched Lugger, and originally intended as a training craft for sailing schools, Sea Scouts, etc.Lugger
| Length | Beam | Weight | Sail Area | Production | No. Built |
| 18 ft 9 in | 6 ft 3 in | 748 lb | 132 sq ft | 1968–present | Approx. 2000 |
The boat that started it all, and still as immensely popular as at its introduction at the Earls Court Boat Show in 1968, when the first wooden production boat, Luka was sold within 29 minutes of the show's opening to the public. Luka is now located in the National Maritime Museum Cornwall. The epitome of rugged simplicity, reliability, and seaworthiness in an open boat, the Lugger is equally at home pottering with the kids or undertaking more adventurous expeditions.
Peterboat
| Length | Beam | Weight | Sail Area | Production | No. Built |
| 4.5 m | 1.7 m | approx | 9.3 m2 | Built by Douglas Elliott at 'John Elliott Boatbuilder' who also built the only Drascombe Mule, essentially a transom version of the 4.5 metre Peterboat. Both designs carry a centreplate | 1 |
| 5 m | 1.7 m | approx | 11.16 m2 | Prototype and half decked version built at 'John Elliott Boatbuilder' by Douglas and John Elliott these were the only two built at that boatyard. | ? |
| 6 m | 2 m | possible approx | 18.51 m2 | Prototype 'Cariad' built for Dick Watkinson, John Watkinson's brother, by John Elliott and Douglas Elliott at 'John Elliott Boatbuilder' had a cast iron centreplate and was originally flush decked. Unusual rig with a curved gunter main and large foresail, a fast boat, 13 knots claimed in a stiff blow. 'Cariad' was later converted to carry a cabin with a coachroof to provide better onboard headroom, similar to the drascombe Longboat Cruiser. | ? |
Designed by John Watkinson in 1973, the Peterboat was not mass-produced and never built in GRP. Only about 10 wooden boats were built by John Elliott, John Kerr, and Norman Whyte. There was an original version of a Peterboat built by John Watkinson, similar decking arrangement to the drascombe Lugger, but with a gunter rig sporting a curved yard with a large jib, only the one was ever built.
Scaffie
| Length | Beam | Weight | Sail Area | Production | No. Built |
| 14 ft 9 in | 5 ft 9 in | 460 lb | 100 sq ft | 1978–present | Approx. 450 |
A smaller drascombe for single-handed sailing, the Scaffie has no centreboard, relying instead on a long central keel and two bilge stub keels. Rig is a single standing lugsail.