BS National Beehive
The Improved National Beehive was a form of Langstroth beehive standardized by two British Standards. The same standard contained the specification of the Smith beehive: these two forms represent the most popular designs used in the Beekeeping in [the United Kingdom|UK].
Design
The National hive, as it is usually known, is based on Langstroth hive design principles: a vertical stack of modular components. Its dimensions are generally smaller and notably the brood chamber is shallower than the typical Langstroth hive to suit a less prolific bee strain.The original specification and the associated Ministry of Agriculture, Fisheries and Food leaflet detail a floor, stand, deeper standard brood boxes, shallower honey Super boxes, a section rack, a crownboard and a roof. The main boxes are square in footprint: the standard brood boxes being tall, and the shallow super tall. The main walls are thick.
The internal frames are supported on runners on two sides of the box, in a deep rebate formed by the two-piece construction of the sides. Because the boxes are square, it is possible to orient frames in two ways with respect to the entrance, either parallel to the entrance block or perpendicular to it.
The National beehive is specifically designed to house frames detailed in the standard. These are wide, with a height of either. In brood boxes, up to twelve frames can be used, but, twelve frames are typically too tight a fit for easy use, and eleven frames are more common; in honey supers, between nine and twelve can be used, depending on the spacing chosen. The National frames have a long top-bar to the frame giving them long lugs of that rest on the runners.
In its original form, the National hive provides bottom beespace—that is, the top surface of the frame bar is flush with the top of the box, and the lower surface of the frame is one bee space above the bottom of the box. Thus, when two boxes are stacked atop one another, there is exactly one beespace vertically between the frames. However, both top and bottom beespace designs may now be found in use.
The roof shown in the MAFF leaflet is a telescoping cover, with internal dimensions of, meaning a relatively loose fit over the topmost box. The total height of the roof is around, though a roof is now also common. Supports set into the roof create a ventilation space above the crownboard rim : the total overlap of the telescoping cover is thus. The roof must be covered with a waterproofing layer: typically this may be galvanized steel sheet.
| Box | Length x width /mm | Height/mm | Volume/l | Frame capacity | Frame width/mm | Frame height/mm | Comb area/m2 | Cells |
| Deep | 460 x 460 374 x 422 | 315 | 50.0 | 12, 11 | 355 | 305 | 2.07 | 93,500 |
| Standard | 460 x 460 374 x 422 | 225 | 35.7 | 12, 11 | 355 | 216 | 1.42 | 63,525 |
| Shallow | 460 x 460 374 x 422 | 150 | 23.8 | 10–12 | 355 | 140 | 0.77–0.93 | 34,700–41,800 |
Features
The National hive has a number of features which—in addition to the inertia of popularity—recommend it.- The standard brood box is considered well suited to non-prolific bees, providing just over 63,000 cells, and has sufficient space both for summer brood rearing, and winter storage.
- There are several methods to increase the size of the brood chamber, if this is required:
- * Use of a larger box, where the height of the frame is, instead of the standard, and the box is thus either or tall.
- * A second standard brood box, thereby doubling the size.
- * Brood and a half chamber of a standard and a shallow box.
- The weight of a full honey super is still manageable by one person, especially as the boxes have secure handholds.