Aston Martin DB6
The Aston Martin DB6 is a grand tourer made by British car manufacturer Aston Martin and was produced from September 1965 to January 1971. The "DB" designation is from the initials of David Brown who built up the company from 1947 onwards.
The DB6 succeeded the Aston Martin DB5 and featured improved aerodynamics and specification over its predecessor.
History and design
After Aston Martin rejected proposals for a replacement for its DB5 from the original DB4 Touring of Milan, the decision was made to focus on their own development car, registered 4 YMC. Wind tunnel testing, begun in February 1965, showed development was necessary to counteract a tendency toward aerodynamic lift causing reduced rear-wheel traction at high speed. Final development phases relied upon DB5 chassis, suitably lengthened and titled MP 219, with rear lip-spoiler and abbreviated Kammback tail Aston Martin previously incorporated in sports-racing prototypes. The decision was made to produce MP 219 as the Aston Martin DB6 although the prototype de Dion rear axle was rejected, Aston's soldiering on with its live-axle configuration reducing time to market, cost and complexity.Introduced at the 1965 London Motor Show, the DB6 was already a dated design notable as the first model engineered following a factory relocation from Feltham to Newport Pagnell. The DB6 has a resemblance to its predecessor, the DB5; with the most noticeable differences being its wheelbase, side profile, split front and rear bumpers and rear panels incorporating the Kammback tail rear end. The tail, combined with the relocated rear-axle and the lengthened wheelbase, provide more stability at high speed. Though fashionable – the rear-end Kamm-styled design was similar to the Ferrari 250 – it did not prove popular with conservative, tradition oriented Aston clientele when the DB6 was introduced. Performance was satisfactory: road-tests of the day observed top speed of the Vantage model between to, with John Bolster aboard a Vantage spec DB6 reaching a two-way average of.
The DB6 continued with then high-tech Armstrong Selectaride cockpit-adjustable rear shock absorbers as available on the DB5. Other highlights include adopting front-door quarter windows, an oil-cooler air scoop low on the front valance, quarter-bumpers at each corner, revised tail-lamp clusters. Additionally, the spoiler affected the overall proportions of the DB6, with an increase in length by approximately two inches.
Other notable changes:
- Roof line raised by two inches improving headroom especially for rear seat passengers
- Genuinely useful leg room for rear passengers
- More steeply raked albeit taller windscreen
- Split front and rear bumpers
- Standard chrome wire wheels on bias-ply whitewall tyres
- Optional 185VR15 Pirelli Cinturato CA67 radial tyres
- Optional power steering
- Optional air conditioning
- Standard ZF five-speed manual unit or a BorgWarner three-speed automatic gearbox available at no extra cost
- Optional Vantage specification retaining triple side-draft Weber 45DCOE carburettors with other minor revisions raising quoted output to 325 hp
Specifications
The DB6 is powered by the twin-overhead camshaft, in-line six-cylinder Aston Martin engine designed by Tadek Marek. The engine, continued with its triple SU carb setup producing at 5,500 rpm; the Vantage engine option is quoted at against the of the DB5. The DB6 was approximately heavier than its predecessor, but offered better stability at high speed, added luggage capacity and added comforts for passengers. The rear suspension used helical coil springs with ride control that was adjustable from inside the car.- Kerb weight:
- Engine: straight-6
- Compression ratio: standard=8.9:1 ; Vantage=9.4:1
- Power: at 5500 rpm
- Power: at 5750 rpm
- Torque: at 4500 rpm
- Top speed:
- 0–60 mph acceleration: 6.2 seconds
- Steering: rack and pinion with optional power assist
- Fuel tank capacity: 19 imp gallons
Later models and variants
The DB6 Mark II was announced on 21 August 1969, identified by distinct flares on front and rear wheel arches and wider 205VR15 Pirelli Cinturato CN72 radial or 815-15V15 Avon Crossply tyres on 1/2" wider wheels. Available as an optional extra for the Mark II was AE Brico electronic fuel-injection combined with the higher compression ratio cylinder head. The Mark II edition shared many parts with the then-new DBS.As with previous Aston Martin models, a high-power DB6 Vantage was offered. It was equipped with three Weber carburettors and higher compression ratio cylinder head.
A convertible body style was also offered, named the Volante. This was introduced at the 1966 London Motor Show. The DB6-based Volante succeeded the earlier Volantes which were built on the last of the DB5 chassis' and were known as "short chassis" Volantes. Of the later DB6-based Volantes just 140 were built, including 29 high-output Vantage Volante versions, highly prized by collectors.
Charles III owns a DB6-based Volante MkII that has been converted to run on E85.
Shooting Brake
A total of six DB6 Shooting-brakes were produced by British coachbuilder Harold Radford, with two more by FLM Panelcraft The engine options were the same as for the DB6 Saloon.- Kerb weight:
- Overall length:
- Overall width:
- Height:
- Turning radius: 34 feet
- Wheelbase:
- Track:
- Fuel tank capacity:
| Coachbuilder | Year | Chassis no. | Engine no. | Vantage spec. | Notes |
| Harold Radford | 1966 | DB6/SB/2272/LC | 400/2792/V | Yes | Unsold at Bonhams' Quail Motorcar Auction in August 2020 with an estimate of US$1,000,000 – 1,200,000. |
| Harold Radford | 1966 | DB6/S/2688/L | 400/2613 | No | Sold at RM Sotheby's Monterey Auction in August 2015 for $682,000. |
| Harold Radford | 1965 | DB6/2387/LNK | 400/2488/VC | Yes | Unsold at Bonhams' Boca Raton Auction in February 2013 with an estimate of US$575,000 – 625,000. |
| FLM Panelcraft | 1967 | DB6/3310/R | 400/3386/VC | Yes | Unsold at RM Sotheby's London Auction in August 2012 with an estimate of £325,000 – £375,000. |