Apple Display Connector


The Apple Display Connector is a display and data connector developed by Apple Inc. as a proprietary modification of the DVI connector. ADC combines analog and digital video signals, USB, and power all in one cable. It was used in later versions of the Apple Studio Display, including the final 17" CRT model, and most versions of the widescreen Apple Cinema Display, after which Apple adopted standard DVI connectors on later models.
ADC was first implemented in the July 2000 Power Mac G4 and Power [Mac G4 Cube|G4 Cube], but disappeared from displays when Apple introduced the aluminum-clad 20", 23", and 30" Apple Cinema Displays in June 2004, which feature separate DVI, USB and FireWire connectors, and their own power supplies. An ADC port was still included with the Power Mac G5 until April 2005, when new models meant the only remaining Apple product with an ADC interface was the single processor Power Mac G5 introduced in October 2004. This single processor Power Mac G5 was discontinued soon after in June 2005.

Compatibility

The Apple Display Connector is physically incompatible with a standard DVI connector. The Apple DVI to ADC Adapter, which cost $149US at launch but was in 2002 available for $99US, takes USB and DVI connections from the computer, adds power from its own integrated power supply, and combines them into an ADC output, allowing ADC monitors to be used with DVI-based machines.
On some models of Power Mac G4 the ADC connector replaced the DVI connector. This change necessitated a passive ADC to DVI adapter to use a DVI monitor.
The ADC carries up to 100 W of power, an insufficient amount to run most 19-inch or bigger CRTs widely available during ADC's debut, nor can it run contemporary flat panels marketed for home entertainment without an adapter. The power limit was an important factor for Apple to abandon ADC when it launched the 30-inch Apple Cinema HD Display.
On newer DVI-based displays lacking ADC, Apple still opted for a single "ganged cable" that connects the separate signal cables to each other so they cannot tangle. Such cables, however, employ standard DVI, power, USB and FireWire connectors, avoiding drawbacks to ADC. Beginning in 2008, Apple began transitioning away from DVI, adopting the increasingly common DisplayPort signalling standard, and developed their own Mini DisplayPort connector beginning with the first LED-backlit Cinema Displays. As of 2013, Apple no longer uses a DVI-based interface for any of its displays.
Apple no longer supports ADC adapters or monitors.

Pin 3 and 11

Power is supplied to the ADC port by an additional finger connector on the video card, which plugs into a slot on the motherboard between the AGP slot and the back panel of the computer; on G4 Macs, some power is also sent through AGP pins 3 and 11. When ADC was introduced, AGP pins 3 and 11 were unassigned. In AGP 8x, pins 3 and 11 were assigned, so because of that, G4s are not directly compatible with AGP 8x. G5 Macs draw all power from the finger connector and therefore are 8x compatible. To use an AGP 8x card in a G4, pins 3 and 11 must be somehow disabled; this can be done by placing tape over the conductive part of the pin, slicing the PCB traces, or on some cards, desoldering surface mount resistors.