Abrial A-2 Vautour
The A-2 Vautour was a single-seat French glider that was designed by Georges Abrial. It performed well at the Vauville competition of 1925.
Design
The Vautour was designed by Georges Abrial of the Institut aérotechnique de Saint-Cyr and built by Louis Peyret. Each wing, joined to a centre-section on top of the fuselage with light dihedral, had a rectangular plan apart from an angled tip and carried a broad chord aileron which filled about 60% of the span. They were of mixed construction with two rectangular section dural spars and plywood ribs. Each wing was braced with a pair of parallel struts, dural tubes enclosed in streamlined, wooden fairings, between the lower fuselage longerons and the wing spars just inside the ailerons.Its fuselage was rectangular in section, with spruce longerons and laminated wood frames. The sides were everywhere vertical but ahead of the wing it narrowed in plan and decreased in depth to a rounded nose. The downward sloping upper surface here was not flat but curved, formed from thin aluminium sheet. The pilot's open cockpit was just in front of the leading edge, with a rubber-cord restrained canvas sheet between him and the aluminium surface, intended as protection in a crash. It contained some basic instrumentation, including an airspeed indicator and an altimeter, both with sensors well above the wing centre-section on a mast, as well as a compass.
The horizontal tail of the Vautour, mounted at mid-fuselage height, was similar in plan to the wing. The tailplane was much narrower than the one piece elevator. The fin was likewise narrower than the rudder and together had a rhomboidal profile, allowing elevator clearance below. Both surfaces were wood-framed and ply covered, with the exception of the fabric covered rudder.
Its landing gear was very simple, with wheels close to the sides on a split axle mounted within the fuselage. Rubber cord shock absorbers were used and the tailskid was also mounted elastically.