6.8mm Remington SPC
The 6.8mm Remington Special Purpose Cartridge is a rimless bottlenecked intermediate rifle cartridge that was developed by Remington Arms in collaboration with members of the U.S. Army Marksmanship Unit and United States Special Operations Command to possibly replace the 5.56 NATO cartridge in short barreled rifles and carbines. Based on the .30 Remington cartridge, it is midway between the 5.56×45mm NATO and 7.62×51mm NATO in bore diameter. It uses the same diameter bullet as the .270 Winchester hunting cartridge.
Development
The 6.8 SPC was designed to address the deficiencies of the terminal ballistics of the 5.56×45mm NATO cartridge currently in service with the armed forces of all NATO-aligned countries. The cartridge was the result of the Enhanced Rifle Cartridge Program. The 6.8 SPC was initially developed by Master Sergeant Steve Holland and Chris Murray, a United States Army Marksmanship Unit gunsmith, to offer superior downrange lethality over the 5.56 NATO/.223 Remington in an M16-pattern service rifle with minimal loss of magazine capacity and a negligible increase in recoil.The program started the design by using a .30 Remington case, which was modified in length to fit into magazines that would be accommodated by the magazine wells of the M16 family of rifles and carbines that are currently in service with the U.S. Armed Forces.
In tests comparing various caliber bullets using a.30 Remington parent case, Holland and Murray determined that a 6.5 mm caliber projectile had the best accuracy and penetration, with historical data going back for decades of US Army exterior and terminal ballistic testing, but a 7 mm projectile had the best terminal performance. The combination of the cartridge case, powder load, and projectile easily outperformed the 7.62×39mm and 5.45×39mm Soviet cartridges, with the new cartridge's muzzle velocity proving to be about faster than the 7.62x39.
The 6.8mm Remington SPC was designed to perform better in short-barreled CQB rifles after diminished performance from the 5.56 NATO when the M16A4 was changed from the rifle configuration to the current M4 carbine. The 6.8 SPC delivers 44% more energy than the 5.56mm NATO at. The 6.8mm SPC is not the ballistic equal of the 7.62×51mm NATO cartridge, but it has less recoil, has been said to be more controllable in rapid fire, and is lighter, allowing operators to carry more ammunition than would otherwise be possible with the larger caliber round. The 6.8 mm generates around of muzzle energy with a bullet. In comparison, the 5.56×45mm round generates around with a bullet, giving the 6.8 mm a terminal ballistic advantage over the 5.56 mm of.
One of the enigmatic features of this cartridge is its being designed for a shorter-barrel carbine-length rifle than the standard rifle length is. The round only gains about for every 25 mm of barrel length past the standard barrel up to barrel lengths around with no gain or loss in accuracy. It also does well in rifles with less than barrels. In recent developments the performance of the 6.8 SPC has been increased by approximately by the work of ammunition manufacturer Silver State Armory LLC and a few custom rifle builders using and designing the correct chamber and barrel specifications. The 6.8mm Remington SPC cartridge weighs, depending on the manufacturer and load, between. Also, more recently, LWRC, Magpul and Alliant Techsystems introduced a new AR-15 designed for the 6.8 SPC which allows for a proprietary 6.8 Magpul P-mags and an overall cartridge length of. The personal defense weapon known as the "Six8" is an SPC II with 1: twist and is able to use all current 6.8 SPC factory ammunition.
Comparison to other military calibers
| Cartridge | Muzzle velocity | drop | velocity | drop | velocity |
| 5.56×45mm M193 | |||||
| 5.56×45mm OTM | |||||
| 6.8×43mm SPC SMK | |||||
| 6.8×43mm SPC V-MAX | |||||
| 7.62×39mm | |||||
| 7.62×51mm SMK |
Typical trajectory information from carbines with drop and velocity calculated at sea level with a zero.
Applications
Military and law enforcement adoption
By late 2004 the 6.8×43mm SPC was said to be performing well in the field against enemy combatants in special operations. However the cartridge was not used by conventional US military personnel. It was not adopted for widespread use due to resistance from officials. The 6.8 SPC was designed for better terminal effectiveness at the shorter ranges of urban combat experienced in Iraq. When fighting in Afghanistan began to intensify, engagements began taking place at greater distances, where the 6.8 SPC begins to falter. Experiments suggested that the comparatively short 6.8 mm bullets became ineffective at longer ranges. In 2007, both the U.S. SOCOM and the U.S. Marine Corps decided not to field weapons chambered in 6.8 mm due to logistical and cost issues.While there are many rumors of evaluations of the cartridge by several major federal and local law enforcement agencies, the US Drug Enforcement Administration has allowed individual agents to purchase the M6A2 D-DEA – which uses the 6.8mm Remington SPC – as an authorized alternative to their duty weapon. In 2010 the Jordanian state-owned arms manufacturer KADDB announced that they would be producing 6.8 mm rifles and carbines for the Jordanian Army. There is also a contract between LWRC, Magpul, Alliant Techsystems and the Saudi Royal Guard for around 36,000 Six8 PDWs and an undisclosed amount of ATK/Federal XD68GD and proprietary Magpul 6.8 Pmags specifically for the LWRC Six8.