Silicate mineral


Silicate minerals are rock-forming minerals made up of silicate groups. They are the largest and most important class of minerals and make up approximately 90 percent of Earth's crust.
In mineralogy, the crystalline forms of silica are usually considered to be tectosilicates, and they are classified as such in the Dana system. However, the Nickel-Strunz system classifies them as oxide minerals. Silica is found in nature as the mineral quartz and its polymorphs.
On Earth, a wide variety of silicate minerals occur in an even wider range of combinations as a result of the processes that have been forming and re-working the crust for billions of years. These processes include partial melting, crystallization, fractionation, metamorphism, weathering, and diagenesis.
Living organisms also contribute to this geologic cycle. For example, a type of plankton known as diatoms construct their exoskeletons from silica extracted from seawater. The frustules of dead diatoms are a major constituent of deep ocean sediment, and of diatomaceous earth.

General structure

A silicate mineral is generally an inorganic compound consisting of subunits with the formula 2n−. Although depicted as such, the description of silicates as anions is a simplification. Balancing the charges of the silicate anions are metal cations, Mx+. Typical cations are Mg2+, Fe2+, and Na+. The Si-O-M linkage between the silicates and the metals are strong, polar-covalent bonds. Silicate anions are invariably colorless, or when crushed to a fine powder, white. The colors of silicate minerals arise from the metal component, commonly iron.
In most silicate minerals, silicon is tetrahedral, being surrounded by four oxides. The coordination number of the oxides is variable except when it bridges two silicon centers, in which case the oxide has a coordination number of two.
Some silicon centers may be replaced by atoms of other elements, still bound to the four corner oxygen corners. If the substituted atom is not normally tetravalent, it usually contributes extra charge to the anion, which then requires extra cations. For example, in the mineral orthoclase, the anion is a tridimensional network of tetrahedra in which all oxygen corners are shared. If all tetrahedra had silicon centers, the anion would be just neutral silica. Replacement of one in every four silicon atoms by an aluminum atom results in the anion, whose charge is neutralized by the potassium cations.

Main groups

In mineralogy, silicate minerals are classified into seven major groups according to the structure of their silicate anion:
Major groupStructureChemical formulaExample
Nesosilicatesisolated silicon tetrahedra4−olivine, garnet, zircon...
Sorosilicatesdouble tetrahedra6−epidote, melilite group
Cyclosilicatesrings2n−beryl group, tourmaline group
Inosilicatessingle chain2n−pyroxene group
Inosilicatesdouble chain6n−amphibole group
Phyllosilicatessheets2n−micas and clays
Tectosilicates3D frameworkx−quartz, feldspars, zeolites

Tectosilicates can only have additional cations if some of the silicon is replaced by an atom of lower valence such as aluminum. Al for Si substitution is common.

Nesosilicates or orthosilicates

Nesosilicates, or orthosilicates, have the orthosilicate ion, present as isolated tetrahedra connected only by interstitial cations. The Nickel–Strunz classification is 09.A –examples include:
  • Phenakite group
  • *Phenakite –
  • *Willemite –
  • Olivine group
  • *Forsterite –
  • *Fayalite –
  • *Tephroite –
  • Garnet group
  • *Pyrope –
  • *Almandine –
  • *Spessartine –
  • *Grossular –
  • *Andradite –
  • *Uvarovite –
  • *Hydrogrossular –
  • Zircon group
  • *Zircon –
  • *Thorite –
  • *Hafnon –
Image:Kyanite crystals.jpg|thumb|Kyanite crystals
  • group
  • *Andalusite –
  • *Kyanite –
  • *Sillimanite –
  • *Dumortierite –
  • *Topaz –
  • *Staurolite –
  • Humite group –
  • *Norbergite –
  • *Chondrodite –
  • *Humite –
  • *Clinohumite –
  • Datolite –
  • Titanite –
  • Chloritoid –
  • Mullite –

    Sorosilicates

Sorosilicates have isolated pyrosilicate anions, consisting of double tetrahedra with a shared oxygen vertex—a silicon:oxygen ratio of 2:7. The Nickel–Strunz classification is 09.B. Examples include:
  • Thortveitite –
  • Hemimorphite –
  • Lawsonite –
  • Axinite –
  • Ilvaite –
  • Epidote group (has both and groups

    Cyclosilicates

Cyclosilicates, or ring silicates, have three or more tetrahedra linked in a ring. The general formula is 2x−, where one or more silicon atoms can be replaced by other 4-coordinated atom. The silicon:oxygen ratio is 1:3. Double rings have the formula 2x− or a 2:5 ratio. The Nickel–Strunz classification is 09.C. Possible ring sizes include:
Some example minerals are:
  • 3-member single ring
  • * Benitoite –
  • 4-member single ring
  • * Papagoite –.
  • 6-member single ring
  • *Beryl –
  • *Bazzite –
  • *Sugilite –
  • *Tourmaline –
  • *Pezzottaite –
  • *Osumilite –
  • *Cordierite –
  • *Sekaninaite –
  • 9-member single ring
  • * Eudialyte –
  • 6-member double ring
  • *Milarite –
The ring in axinite contains two B and four Si tetrahedra and is highly distorted compared to the other 6-member ring cyclosilicates.

Inosilicates

Inosilicates, or chain silicates, have interlocking chains of silicate tetrahedra with either, 1:3 ratio, for single chains or, 4:11 ratio, for double chains. The Nickel–Strunz classification is 09.D – examples include:

Single chain inosilicates

  • Pyroxene group
  • *Clinopyroxene subgroup
  • **Aegirine –
  • **Augite –
  • **Diopside –
  • **Hedenbergite –
  • **Jadeite –
  • **Pigeonite –, where 0.1 ≤ x ≤ 0.4, x + y + z = 1 and y1 + z1 = 1
  • **Spodumene –
  • *Orthopyroxene subgroup
  • **Enstatite –
  • **Ferrosilite –
  • Pyroxferroite -
  • Rhodonite –
  • Wollastonite group
  • *Pectolite –
  • *Wollastonite –

    Double chain inosilicates

  • Amphibole group
  • *Anthophyllite –
  • *Cummingtonite series
  • **Cummingtonite –
  • **Grunerite –
  • *Tremolite series
  • **Tremolite –
  • **Actinolite –
  • *Hornblende –
  • *Sodium amphibole group
  • **Glaucophane –
  • **Riebeckite –
  • **Arfvedsonite –

    Phyllosilicates

Phyllosilicates, or sheet silicates, form parallel sheets of silicate tetrahedra with or a 2:5 ratio. The Nickel–Strunz classification is 09.E. All phyllosilicate minerals are hydrated, with either water or hydroxyl groups attached. Many phyllosilicates are clay-forming and may be further classified as 1:1 clay minerals and 2:1 clay minerals. Below are some major phyllosilicate mineral species and their chemical formulas, with group and series names in italics:
Image:KaolinUSGOV.jpg|thumb|Kaolinite
  • Ajoite –
  • Apophyllite group
  • *Fluorapophyllite- –
  • Bannisterite –
  • Carletonite –
  • Cavansite –
  • Chlorite group –
  • *Chamosite –
  • *Clinochlore –
  • *Cookeite –
  • Chrysocolla –
  • Ekanite –
  • Gyrolite –
  • Hisingerite –
  • Imogolite –
  • Kaolinite-Serpentine group
  • *Greenalite –
  • *Kaolinite subgroup
  • **Dickite –
  • **Kaolinite –
  • **Halloysite –
  • *Serpentine subgroup
  • **Amesite –
  • **Antigorite –
  • **Chrysotile –
  • **Lizardite –
  • Mica group
  • *Brittle mica group
  • **Clintonite –
  • **Margarite –
  • *Dioctahedral mica group
  • **Celadonite subgroup
  • ***Celadonite –
  • **Glauconite –
  • **Muscovite –
  • **Paragonite –
  • **Roscoelite –
  • *Trioctahedral mica group
  • **Aspidolite –
  • **Biotite subgroup –
  • ***Annite –
  • ***Phlogopite –
  • **Lepidolite –
  • **Zinnwaldite series –
  • Neptunite –
  • Okenite –
  • Palygorskite group
  • *Palygorskite –
  • *Tuperssuatsiaite –
  • Pentagonite –
  • Pyrophyllite-Talc group
  • *Pyrophyllite –
  • *Talc –
  • Sepiolite group
  • *Sepiolite –
  • *Falcondoite –
  • Smectite group
  • *Hectorite –
  • *Montmorillonite –
  • *Nontronite –
  • *Saponite –
  • *Stevensite –
  • Stilpnomelane group
  • *Stilpnomelane –
  • Vermiculite –

    Tectosilicates

Tectosilicates, or "framework silicates," have a three-dimensional framework of silicate tetrahedra with in a 1:2 ratio. This group comprises nearly 75% of the crust of the Earth. Tectosilicates, with the exception of the quartz group, are aluminosilicates. The Nickel–Strunz classifications are 9.F, 9.G, and 4.DA. Below are some major tectosilicate mineral species and their chemical formulas, with group and series names in italics:
  • Quartz group –
  • *Chalcedony – cryptocrystalline variety of silica composed mostly of quartz with some moganite
  • *Polymorphs of silica
  • **α-quartz – trigonal, "normal" quartz under
  • **β-quartz – hexagonal, high-temperature quartz
  • **Coesite – monoclinic
  • **Cristobalite – tetragonal
  • **Melanophlogite – cubic or tetragonal, rare
  • **Moganite – monoclinic
  • **Stishovite – tetragonal, extremely hard and dense
  • **Tridymite – orthorhombic
  • Feldspar group
  • *Alkali feldspar series
  • **Microcline –
  • **Orthoclase –
  • **Anorthoclase –
  • **Sanidine –
  • *Plagioclase feldspar series
  • **Albite –
  • **Oligoclase –
  • **Andesine –
  • **Labradorite –
  • **Bytownite –
  • **Anorthite –
  • *Other feldspars
  • **Buddingtonite —
  • **Celsian –
  • **Hyalophane –
  • Feldspathoid group
  • *Cancrinite subgroup
  • **Afghanite –
  • **Cancrinite –
  • **Sacrofanite –
  • *Leucite –
  • *Nepheline subgroup
  • **Nepheline –
  • *Sodalite subgroup
  • **Hauyne –
  • **Lazurite –
  • **Nosean –
  • **Sodalite –
  • **Tugtupite –
  • Scapolite group
  • *Marialite –
  • *Meionite –
  • Zeolite group
  • *Amicite –
  • *Analcime –
  • *Brewsterite subgroup –
  • *Chabazite-Lévyne subgroup
  • **Chabazite –
  • **Lévyne –
  • *Clinoptilolite subgroup –
  • *Erionite subgroup –
  • *Faujasite subgroup –
  • *Ferrierite subgroup –
  • *Heulandite subgroup –
  • *Laumontite –
  • *Mordenite –
  • *Natrolite subgroup
  • **Mesolite –
  • **Natrolite –
  • **Scolecite –
  • *Paulingite subgroup –
  • *Phillipsite subgroup
  • **Phillipsite –
  • *Pollucite –
  • *Stilbite subgroup
  • **Stellerite –
  • **Stilbite –
  • *Thomsonite subgroup –
  • *Yugawaralite –