Renard R.33
The Renard R.33 was a Belgian training aircraft with aerobatic capability. Two were flown in 1934 but no more were produced.
Design
When the Renard R.33 design was begun, it was intended as a touring aircraft but as it progressed it became apparent that a more suitable rôle was as a trainer for military reserve pilots and crew. The R.33 allowed pilots to develop their aerobatics and the crew their navigational skills.It was a parasol wing monoplane, its wings braced to the lower fuselage with streamlined steel tube V-struts. The centre of the wing, thinner than the outer parts, was close to the fuselage and was braced there on short cabane struts. The plan was roughly elliptical, though the leading edge was straight over about half the span and there was a deep, rounded cut-out in the trailing edge to improve the pilot's field of view. There was no dihedral. The wing was all wood, built around a pair of box spars apart and plywood covered. Its ailerons occupied almost 60% of the span.
The R.33's fuselage was a slender steel tube structure, flat sided though with a rounded upper decking. Its pointed nose partially exposed the five cylinders of the Renard 120 radial engine. Engine and cockpit areas were covered with metal and the rest with fabric. A long forward fuselage provided a space between engine and cockpits for fuel tanks and baggage. The tandem open cockpits were raised enough for the pilots to be able to see both above and below the wing. Dual controls were fitted, though the forward set could be removed for a passenger. The empennage was conventional, with balanced control surfaces; the fin was small, with a large, rounded rudder that extended to the keel and the tailplane, mounted at mid-fuselage height and braced from below with two struts on each side, was far enough forward to keep the elevators clear of the rudder.
The Renard had a fixed undercarriage with two mainwheels with axles on V-struts from the central lower fuselage. Faired long oleo struts were attached to the upper fuselage. The wheels had cable brakes; the pilot could choose to use them differentially operation for steering on the ground. There was a steel spring tailskid which could castor freely.