Off-roading
Off-roading is the act of driving or riding in a vehicle on unpaved surfaces such as sand, dirt, gravel, riverbeds, mud, snow, rocks, or other natural terrain. Off-roading ranges from casual drives with regular vehicles to competitive events with customized vehicles and skilled drivers.
Off-road vehicle
Off-road vehicles are either capable of or specifically developed for off-road driving. These vehicles often have features designed specifically for use in off-road conditions such as suspension lifts, off-road tires, skid plates, snorkels, roll cages, or strengthened drivetrains.Tools
- Recovery board
- High lift jack
- Snatch strap
Types of recreational off-roading
Dune bashing
Dune bashing is a specific form of off-roading performed on sand dunes.Dune Buggies, Sport-utility vehicles, and ATVs are often used. Vehicles driven on sand dunes are often equipped with a roll cage for safety in the case of an overturn. The tire pressure is often reduced to gain more traction by increasing the footprint of the tire and lowering the ground pressure of the vehicle on the sand, comparable to a person wearing snowshoes to walk on snow without sinking. Some cars are equipped with beadlock wheels, which allow tire pressure to be lowered even further without risking separation of the tire and rim.
Upon entering the desert, it is customary for drivers to meet with a pack of other vehicles and a group leader before proceeding. The group leader then leads the pack through the stunts in a single file line. The rationale for this technique is to prevent drivers from becoming disoriented and getting lost.
Off-road racing
Desert racing
High-speed racing in the desert includes chases and racing at maximum speed through rough desert terrain with numerous pots and bumps. Drivers often use rear-wheel drive and 4-wheel drive trucks with long-travel suspension and wide stance between the front enlarged tires, which maintains optimal stability at high speed. These types of trucks are often called Trophy trucks or PreRunners.Rock racing
Rock racing involves driving over rocks, but unlike rock crawling, does not specify penalties for striking cones, backing up, or winching. In addition, rock racing incorporates a level of high-speed racing that is not characteristic of rock crawling.Rallying
See article: RallyMudding and mud plugging
Mudding is off-roading through an area of wet mud or clay, leading to extremely low traction and problems with moving forward. The goal is to drive as far as possible without getting stuck. There are many types of tires that are often used for this activity, including balloon tires, mud-terrain tires and paddle tires. The activity is popular in the United States, although it is illegal on public land due to the environmental impact.Mud plugging, as practiced in the United Kingdom, refers to the motorsport of classic trials, where the main objective is to complete a challenging course of roads and off-road terrain.
This form of motorsport is one of the oldest to survive to this day, dating back at least to the 1920s.
Rock crawling
involves driving over rocky terrain, with the goal of getting as far as possible with the fewest penalties. Penalties are received for striking cones, using a winch to get unstuck, going out of bounds, and going in reverse. These rules lead to the sport being technical, with drivers having to plan ahead to reduce the penalties they receive. Vehicles used for rock crawling are usually modified with different tires, suspension components that allow greater axle articulation, and changes in the differential gear ratio to obtain characteristics suitable for low-speed operation for traversing obstacles. Commonly, rock crawlers have a "spotter", who is an assistant on foot by the vehicle to provide information about areas out of the driver's field of view.Competitive trials
All progress is made at low speed and the emphasis is on skill rather than on finishing first, although trialing can be highly competitive. There are three traditional forms of off-road trialing. During some competitive events, such as the Turkey Run in Idaho and other events around the United States, point systems may be used to determine rewards.RTV trialing
RTV trialing is the most common form of trialing. As the name suggests, it is for vehicles that are road-legal. This excludes vehicles that are highly modified or specially built. RTV-class vehicles can carry a wide range of suspension modifications, as well as off-road tires, recovery winches, raised air intakes, etc. Vehicles on RTV trials are usually best described as "modified from standard"—they use the standard chassis, drive-train, and body that the vehicle was built with, but are fitted with a wide array of modifications to assist in the trailing. Whilst modification is not necessarily required for an RTV trial, at the very least the vehicle would be expected to have some underbody and over-the-body protection such as skid plates or roll cages, often made from durable stainless steel, aluminium or mild steel. RTV courses are intended to be non-damaging and driven at little more than a walking pace and a course properly laid out would be drivable without damage. However, the terrain usually includes steep slopes, water, side slopes, deep ruts, and other obstacles that could potentially damage a vehicle if mistakes are made or poor driving techniques are used. As such, the use of modifications can increase the chances of success.RTV trials usually take place on farmland, a quarry site, or at a dedicated off-road driving center and are usually organized by a dedicated trialing body and are vertically placed. The gates are just wide enough to get a standard vehicle through. Vehicles start in a stagger, proceeding one by one, and are deemed to have cleared a gate if at least one of the front wheel hubs passes between the canes. The vehicle's attempt ends when it comes to a stop. Long-wheelbase vehicles are usually allowed to perform a three-point turn if needed, providing the driver declares where the turn is going to be made before they attempt the course. This can also be called a "shunt", where the driver has to attempt a gate and then shout "shunt". They are then allowed a space of one and a half car lengths to reverse and line the car better to enter through the gate
The course between the gates is a "section": between the start line and the first gate is "Section 1", the part between the first and second gates is "Section 2" and so on. An RTV course is often laid out so that each section is progressively more difficult, although this is not always the case. If a driver fails to complete Section 1 they are given 10 points. If the attempt ends in Section 2, 9 points are awarded, etc. A clear round results in gaining only 1 point. A day's event will consist of many different courses and the driver with the lowest score is the winner.
Since the terrain covered in RTV trials should be well within the capabilities of any reasonably capable vehicle, these trials emphasize driver skill and ground-reading abilities. Skill and experience have a larger bearing on success than having a well-equipped and modified car.
CCV trialing
Cross Country Vehicle trialing is the next step up from RTV trialing and is open to non-road-legal vehicles, which greatly increases the scope for modification. The terrain covered will be of greater difficulty than that found on an RTV trial. Since there is a risk of touching rocks and trees with the bodywork, CCV trialing will usually require more careful use of speed to get the vehicle across certain obstacles will attempting to mitigate the risk of vehicle damage. Whilst no trial is intended to be vehicle-damaging, mistakes and accidents are inevitable. A standard-specification vehicle would not be expected to be able to complete a CCV course, but it would still be possible.The event is run along the same lines as RTV, with a course made up of cane-marked gates.
CCV trialing differs greatly from RTV trials in the vehicles used. Since CCV judges adopt an "anything goes" attitude, CCV trials rely on having the correct vehicle to a much greater extent than in an RTV trial. Competitors can design and build vehicles that are much more optimized for off-road use, than in the lower ranks of trialing. CCV vehicles have powerful engines, high ground clearance, light, minimalist bodywork, and good approach and departure angles. For many years, in the UK, the ultimate CCV vehicle could be built by taking the chassis of a Range Rover, removing the body, cutting the chassis down to an 80-inch wheelbase, and attaching it to the body of a Series I Land Rover, retaining the Range Rover's V8 engine and coil-spring suspension in a light, maneuverable body. In recent years, the value of early Land Rovers and Range Rovers has risen to the extent that this is no longer practical. CCV trailers now usually base their vehicles around Land Rover Defenders or a standard 100-inch chassis from a Range Rover or Series I Discovery. The Suzuki SJ series of vehicles also make good bases for CCV-spec vehicles. Some vehicles are specially built, taking the form of light "buggies" with tractor tires and "fiddle" brakes for the best performance.
Vehicles are required to meet certain safety regulations. Roll-cages must be fitted and be built to a suitable standard, recovery points must be fitted front and rear and fuel tanks must meet certain standards. A 4-point harness for all occupants is required and a fire extinguisher is recommended.