Gotha WD.3


The Gotha WD.3 was a prototype maritime reconnaissance floatplane developed during World War I by Gothaer Waggonfabrik for the Imperial German Navy's Naval Air Service. The three-seat aircraft used the pusher configuration with the engine behind the crew. It was lacking in performance compared to aircraft with the more common tractor configuration with the engine in the nose and was not approved for production. The single prototype completed was used as a training aircraft; its ultimate fate is unknown.

Development and description

Gotha had built a series of single-engine maritime reconnaissance floatplanes for the Naval Air Service since 1913, initially patterned on the British Avro 503. These were unarmed scouts, but the German Imperial Naval Office decided to arm this type of aircraft. In the days before the development of the interrupter gear that allowed a machinegun to fire through the propeller, the most effective way to mount a gun with a forward firing arc was to dispense with a conventional fuselage, relocate the engine to the rear of a nacelle that also carried the cockpit, weapons, and wings, and carry the tail structure on booms stretching back either side of the engine and its propeller.
The WD.3 was a three-seat biplane with twin floats that connected to the wings and nacelle via multiple struts. While Gotha had license-built the French tractor-engined, twin-boom Caudron G.3 as the LD.3 and LD.4, the WD.3 used molded-plywood booms instead of a lattice frame like the G.3. The booms incorporated the inner struts connecting the wings and were also attached to the lower wing. They were connected at their ends by the horizontal stabilizer; in its middle was a small vertical stabilizer. Also at the end of each boom was a rudder. The fuselage nacelle had two cockpits, the forward one for the two observers and the rear one for the pilot. One observer operated the Parabellum MG14 machinegun and the other worked the wireless telegraph. The rear of the nacelle contained the water-cooled Mercedes D.III straight-six engine.

Operational history

, chief designer of Gotha's seaplane department, began work on the WD.3 in August 1914, the same month that World War I began. The prototype was not delivered until 14 September 1915, which lengthy development time showed that the project was not a high priority. Testing by the Seaplane Experimental Command at Warnemünde revealed that the WD.3 was overweight and had mediocre performance. The command therefore ruled out the possibility of any further pusher-configuration aircraft. It used the prototype for training before transferring it to the bases at Stralsund and Wiek where it is known to have made a training flight on 2 August 1916. No WD.3 was located when the Allies of [World War I|Allies] inspected the German seaplane bases in December 1918.

Operators