Underwater acoustics
Underwater acoustics is the study of the propagation of sound in water and the interaction of the mechanical waves that constitute sound with the water, its contents and its boundaries. The water may be in the ocean, a lake, a river or a tank. Typical frequencies associated with underwater acoustics are between 10 Hz and 1 MHz. The propagation of sound in the ocean at frequencies lower than 10 Hz is usually not possible without penetrating deep into the seabed, whereas frequencies above 1 MHz are rarely used because they are absorbed very quickly.
Hydroacoustics, using sonar technology, is most commonly used for monitoring of underwater physical and biological characteristics. Hydroacoustics can be used to detect the depth of a water body, as well as the presence or absence, abundance, distribution, size, and behavior of underwater plants and animals. Hydroacoustic sensing involves "passive acoustics" or active acoustics making a sound and listening for the echo, hence the common name for the device, echo sounder or echosounder.
There are a number of different causes of noise from shipping. These can be subdivided into those caused by the propeller, those caused by machinery, and those caused by the movement of the hull through the water. The relative importance of these three different categories will depend, amongst other things, on the ship type.
One of the main causes of hydro acoustic noise from fully submerged lifting surfaces is the unsteady separated turbulent flow near the surface's trailing edge that produces pressure fluctuations on the surface and unsteady oscillatory flow in the near wake. The relative motion between the surface and the ocean creates a turbulent boundary layer that surrounds the surface. The noise is generated by the fluctuating velocity and pressure fields within this TBL.
The field of underwater acoustics is closely related to a number of other fields of acoustic study, including sonar, transduction, signal processing, acoustical oceanography, bioacoustics, and physical acoustics.
History
Underwater sound has probably been used by marine animals for millions of years. The science of underwater acoustics began in 1490, when Leonardo da Vinci wrote the following,In 1687 Isaac Newton wrote his Mathematical Principles of Natural Philosophy which included the first mathematical treatment of sound. The next major step in the development of underwater acoustics was made by Daniel Colladon, a Swiss physicist, and Charles Sturm, a French mathematician. In 1826, on Lake Geneva, they measured the elapsed time between a flash of light and the sound of a submerged ship's bell heard using an underwater listening horn. They measured a sound speed of 1435 metres per second over a 17 kilometre distance, providing the first quantitative measurement of sound speed in water. The result they obtained was within about 2% of currently accepted values. In 1877 Lord Rayleigh wrote the Theory of Sound and established modern acoustic theory.
The sinking of Titanic in 1912 and the start of World War I provided the impetus for the next wave of progress in underwater acoustics. Systems for detecting icebergs and U-boats were developed. Between 1912 and 1914, a number of echolocation patents were granted in Europe and the U.S., culminating in Reginald A. Fessenden's echo-ranger in 1914. Pioneering work was carried out during this time in France by Paul Langevin and in Britain by A B Wood and associates. The development of both active ASDIC and passive sonar proceeded apace during the war, driven by the first large scale deployments of submarines. Other advances in underwater acoustics included the development of acoustic mines.
In 1919, the first scientific paper on underwater acoustics was published, theoretically describing the refraction of sound waves produced by temperature and salinity gradients in the ocean. The range predictions of the paper were experimentally validated by propagation loss measurements.
The next two decades saw the development of several applications of underwater acoustics. The fathometer, or depth sounder, was developed commercially during the 1920s. Originally natural materials were used for the transducers, but by the 1930s sonar systems incorporating piezoelectric transducers made from synthetic materials were being used for passive listening systems and for active echo-ranging systems. These systems were used to good effect during World War II by both submarines and anti-submarine vessels. Many advances in underwater acoustics were made which were summarised later in the series Physics of Sound in the Sea, published in 1946.
After World War II, the development of sonar systems was driven largely by the Cold War, resulting in advances in the theoretical and practical understanding of underwater acoustics, aided by computer-based techniques.
Theory
Sound waves in water, bottom of sea
A sound wave propagating underwater consists of alternating compressions and rarefactions of the water. These compressions and rarefactions are detected by a receiver, such as the human ear or a hydrophone, as changes in pressure. These waves may be man-made or naturally generated.Speed of sound, density and impedance
The speed of sound is related to frequency and wavelength of a wave by.This is different from the particle velocity, which refers to the motion of molecules in the medium due to the sound, and relates the plane wave pressure to the fluid density and sound speed by.
The product of and from the above formula is known as the characteristic acoustic impedance. The acoustic power crossing unit area is known as the intensity of the wave and for a plane wave the average intensity is given by, where is the root mean square acoustic pressure.
At 1 kHz, the wavelength in water is about 1.5 m. Sometimes the term "sound velocity" is used but this is incorrect as the quantity is a scalar.
The large impedance contrast between air and water and the scale of surface roughness means that the sea surface behaves as an almost perfect reflector of sound at frequencies below 1 kHz. Sound speed in water exceeds that in air by a factor of 4.4 and the density ratio is about 820.
Absorption of sound
Absorption of low frequency sound is weak. . The main cause of sound attenuation in fresh water, and at high frequency in sea water is viscosity. Additional contributions at lower frequency in seawater are associated with the ionic relaxation of boric acid and magnesium sulfate.Sound may be absorbed by losses at the fluid boundaries. Near the surface of the sea losses can occur in a bubble layer or in ice, while at the bottom sound can penetrate into the sediment and be absorbed.
Sound reflection and scattering
Boundary interactions
Both the water surface and bottom are reflecting and scattering boundaries.Surface
For many purposes the sea-air surface can be thought of as a perfect reflector. The impedance contrast is so great that little energy is able to cross this boundary. Acoustic pressure waves reflected from the sea surface experience a reversal in phase, often stated as either a "pi phase change" or a "180 deg phase change". This is represented mathematically by assigning a reflection coefficient of minus 1 instead of plus one to the sea surface.At high frequency or when the sea is rough, some of the incident sound is scattered, and this is taken into account by assigning a reflection coefficient whose magnitude is less than one. For example, close to normal incidence, the reflection coefficient becomes, where h is the rms wave height.
A further complication is the presence of wind-generated bubbles or fish close to the sea surface. The bubbles can also form plumes that absorb some of the incident and scattered sound, and scatter some of the sound themselves.
Seabed
The acoustic impedance mismatch between water and the bottom is generally much less than at the surface and is more complex. It depends on the bottom material types and depth of the layers. Theories have been developed for predicting the sound propagation in the bottom in this case, for example by Biot and by Buckingham.At target
The reflection of sound at a target whose dimensions are large compared with the acoustic wavelength depends on its size and shape as well as the impedance of the target relative to that of water. Formulae have been developed for the target strength of various simple shapes as a function of angle of sound incidence. More complex shapes may be approximated by combining these simple ones.Propagation of sound
Underwater acoustic propagation depends on many factors. The direction of sound propagation is determined by the sound speed gradients in the water. These speed gradients transform the sound wave through refraction, reflection, and dispersion. In the sea the vertical gradients are generally much larger than the horizontal ones. Combining this with a tendency towards increasing sound speed at increasing depth, due to the increasing pressure in the deep sea, causes a reversal of the sound speed gradient in the thermocline, creating an efficient waveguide at the depth, corresponding to the minimum sound speed. The sound speed profile may cause regions of low sound intensity called "Shadow Zones", and regions of high intensity called "Caustics". These may be found by ray tracing methods.At the equator and temperate latitudes in the ocean, the surface temperature is high enough to reverse the pressure effect, such that a sound speed minimum occurs at depth of a few hundred meters. The presence of this minimum creates a special channel known as deep sound channel, or SOFAR channel, permitting guided propagation of underwater sound for thousands of kilometers without interaction with the sea surface or the seabed. Another phenomenon in the deep sea is the formation of sound focusing areas, known as convergence zones. In this case sound is refracted downward from a near-surface source and then back up again. The horizontal distance from the source at which this occurs depends on the positive and negative sound speed gradients. A surface duct can also occur in both deep and moderately shallow water when there is upward refraction, for example due to cold surface temperatures. Propagation is by repeated sound bounces off the surface.
In general, as sound propagates underwater there is a reduction in the sound intensity over increasing ranges, though in some circumstances a gain can be obtained due to focusing. Propagation loss is a quantitative measure of the reduction in sound intensity between two points, normally the sound source and a distant receiver. If is the far field intensity of the source referred to a point 1 m from its acoustic center and is the intensity at the receiver, then the propagation loss is given by.
In this equation is not the true acoustic intensity at the receiver, which is a vector quantity, but a scalar equal to the equivalent plane wave intensity of the sound field. The EPWI is defined as the magnitude of the intensity of a plane wave of the same RMS pressure as the true acoustic field. At short range the propagation loss is dominated by spreading while at long range it is dominated by absorption and/or scattering losses.
An alternative definition is possible in terms of pressure instead of intensity, giving, where is the RMS acoustic pressure in the far-field of the projector, scaled to a standard distance of 1 m, and is the RMS pressure at the receiver position.
These two definitions are not exactly equivalent because the characteristic impedance at the receiver may be different from that at the source. Because of this, the use of the intensity definition leads to a different sonar equation to the definition based on a pressure ratio. If the source and receiver are both in water, the difference is small.